Well there you go. The thing itself completed. This project was for me fairly easy and a good way to get back to nuts and volts electronics after many years away. This not a bad first build for any one just go slow and use some care in assembly. If I could do anything differently it would be pay more attention to compenent position prior to soldering anything and give a little space around the penetrations in the casing to allow for washers and nuts.
The soldering also leaves something to be desired. It could be more cleanly executed and the excess flux needs to be removed. But the ultimate test is does it work and it most certainly did on the first try so what more needs to be said?
Posts
No comments:
Post a Comment