This is the board with all components in place (except that busted diode).
A close up of the switch sockets after mounting. Since th eswitch and toggle switch help hold the board in place they are mounted on the back of the board. One note of caution: The holes are large in relation to the leads and if you are in cautious with the solder you'll end up with a bunch of it stuck up underneath the switch shorting out who knows what. It's a major pain in the ass to remove. Also getting all the pins lined up was a little tricky but patience and a pair of needlenose pliers will get it all right.
The completed board assembly with switch in place.
Posts
No comments:
Post a Comment